Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi there! I need some help. I haven't been a hands-on network engineer in a long time so please excuse my lack of scripting knowledge. I have been asked to write a script that will change the configuration on a given port in the event of a reachabil...
Greetings to all!I have a 6001 running 7.0(2)N1(1) and I'm running in to an issue or at least I think I am. Here is a napkin drawing of the topology. Attached is more details on the Panduit cable. It’s really just a hydra cable (1x40G breaks out to 4...
Greetings to all, I have two questions... I would like to disable MoH when I'm on specifc calls. Is there a way to do that? Also I can't find anything about setting up a live audio feed on the 520, can someone point me in the right direction?Thanks, ...
Greetings to all, The company I work for is moving from your old Siemans PBXs over to a complete UC implementation. The one thing that I'm trying to figure out is there a good suggestion on what make and model phones for connecting to a VG224?Thanks,...
GReetings to all,I have a UC520 and I have a 1 SIP inbound that rings a blast group to ring the phones around my house, but I would like to have it so when someone leaves a voice mail that the MWI goes on all the phones...I found an old post (from 20...
This might be a silly question but does the uplink have to be a trunk port? I haven't seen any configs using an access port, but shouldn't I be able to use access ports? Thanks, Tom
Did his solution work? I'm curious because the Cisco docs on this subject are really poor and there is almost nothing on the Internet about how to config it. Thanks, Tom
