About eliran mor

eliran mor · 05-29-2019

HelloWe have several Telepresence units SX20 (more then 10)all of them have Tc 7.3.16 versionregistered to CUCM 8.6.2 and provisioned with TMS ver 14.3.2With most units i can access the gui via https but in 3 units i can access only via http (https g...

eliran mor · 04-15-2019

Hi all,i need to change some settings on a voice gateway registered to cucm , the VGW has 16 pri connected to it and receiving calls 24/7 obviusly no all the pri are full all the time or busy but during the whole day there are some active calls on it...

eliran mor · 06-26-2012

Hi alli would like to connect Audiocodes 320hd ip phone to cucm ,i have connected the phone to the networkadded it manualy as 3rd party sip (did it both as basic and advanced)and its not working , the phone got address from dhcp (was able to get to i...

eliran mor · 02-26-2012

hi alli have cucm 7.x when i activate live record it stops after exactly 30 minutes and i dont recieve the voicemail, if i end the call prior to 30 minutes i DO get the voicemail just finewhere is the restriction ? and what could be the reason that i...

eliran mor · 05-29-2019

On both https is set to on , on the https section of the security section and both have a valid certificate

eliran mor · 04-16-2019

Hi HarrisThank you for the reply , i used your suggested command and it seem to be working and less and less calls are coming in to the voice gateway, however how can i see on which serial interface i have applied the command , on show ISDN status o...

eliran mor · 04-15-2019

dear Dennis i think you dont understand my request , there is no "behavior" or a problem with the ios or the gateway i simply want to make some configurations which require me to stop the mgcp and as i said there are calls on the router on any given ...

eliran mor · 06-24-2015

Hello, im having the same issues with DX80 and cucm 10.5.1 , unfortunetly i installed the FW before the device pack , what should i doi can see the DX 80 in device defaults but i wont registerand also what do i need to configure on the endpoint side ...

eliran mor · 11-21-2012

Hi Stephanie I saw your responce and it seem you really know what you are talking abouyplease help meim trying to configure simple mail relay with unity connection 8.6 i am using a smart host (made sure the ip address of the unity connection server i...

Member Since	‎02-26-2012 11:34 PM
Date Last Visited	‎08-19-2022 12:03 AM
Posts	10

User Statistics

User Activity

SX20 - Can't access Gui Via Https

How to Automatically Shutdown PRI or Controller E1 when there are no calls on MGCP

How to connect Audiocodes 320hd Ip Phone to CUCM 8

Live Recording stops after exactly 30 minutes

Re: SX20 - Can't access Gui Via Https

Re: How to Automatically Shutdown PRI or Controller E1 when there are no calls on MGCP

Re: How to Automatically Shutdown PRI or Controller E1 when there are no calls on MGCP

Hello, im having the same

Re: Unity Connection 7 forward voicemail to email