Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I purchased VIRL but the ASAv appliance doesn't have any .pkg files loaded for Anyconnect. I do have the ability to download the files directly from Cisco but I want to make sure I'm not going to run into a license issue. Does VIRL or the ASAv give m...
Does Cisco have a published document that shows the requirements for their SCRYPT implementation (type 9 encryption)? I want to be able to generate all of my secrets off the device and them import them later but I need to know the values they use for...
I have two N9Ks connected to each other with OSPF running between them using unnumbered loopbacks. If I go to either switch and do a show ip route x.x.x.x (to it's peer) I get two possible candidate routes. Everything works fine and I can ping my ne...
Does anyone know the MIB or OID that I can use to disable a WLAN on a WLC? I already tried CISCO-LWAPP-WLAN but it doesn't have anything that I can use to shut it down.Thanks!!
Does anyone have documentation on all the fields in an elam capture?I am troubleshooting a very wierd vPC problem and I am getting drop_oth. I notice my di field has 11a0 or 11a1. On a successful packet my di field is a38 or a39.The di and associat...
Did anyone ever get a solution to this? I have the same issue - 20Mbps through Firepower but 100 as soon as I remove the service policies. I'm not using URL or SSL and only have 4 rules.
@Diana Karolina Rojas wrote:
Estimated,
Please read the last reply from this post https://supportforums.cisco.com/t5/lan-switching-and-routing/access-list-wrong-order/td-p/3070419
Do not forget to rate useful answers.
Best Regards,
That defini...
I have this same problem and I've tested it on two versions; IOS-15.6.2 and XE-16.07.
If I enter this:
ip access-list standard TEST
permit 10.128.2.94
permit 10.190.9.100
permit 10.216.190.46
I end up with this
Standard IP access list TEST 30 per...
There is an obscure MIB called AIRESPACE.MIB which contains the correct OID for it under 1.3.6.1.4.1.14179.2.1.1.1.6. The Cisco download for this MIB comes up as invalid in all of my parsers but searching it does produce the correct OIDs
