Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Any guidance here would be appreciated - I managed to get one of two 1572 outdoor AP's connected for a day and then it dropped off and I can't get either of them to connect back.This is the error message I'm seeing on the Trap Logs:AAA Authentication...
Is it possible to achieve a redundancy over different types of links that both advertise the same subnet over OSPF?Would either of the configurations above work? Either the router and firewall are connected to the switch or the firewall is connecte...
I'm using a 4G connection for a redundant router and am able to ping 8.8.8.8 and my domain controller, but I am unable to ping the loopback or WAN port of the router.This is the first time I have tried to configure something like this and had to send...
Hi all, just wanting to confirm whether or not this solution is possible - the switch is unable to do "ip nat pool...." which a router can do and that might be what is preventing me from getting this to work.The Brief:I am trying to get 4 x Outdoor A...
Is it possible to enable LAG via two separate routed links such as MPLS and RADIUS via LTE ISR?I have a site that currently has connectivity via the clients network that routes us back to our ISP MPLS router via a 5505 ASA connecting to their PA220 F...
Ahhh......ffs...... the user on site was connecting the cable to the PoE port instead of the Ethernet port despite all the diagrams I sent through. AP's have now connected. Thanks for the help anyway @Leo Laohoo
Sorry I forgot to add - the config itself doesn't seem to be working beyond the router as even when connected to the switch, the switch does not come online.
Hi Balaji,I applied the change to the ACL but still no luck with the internet share.Should I just redesign this setup and have the switch effectively be a L2 switch just working with the internet source?I have an 819 router which I can use instead. ...
Thanks Balaji - I will just enable the redundant link then.It would be too difficult to just split networks like that and achieve a good result.There's only one router being configured here. The MPLS connection comes via the firewall IPSec tunnel ba...
