Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi Everyone,I've run into a strange issue since yesterday with our Expressway Core and Edge deployment.The setup was working fine until yesterday, and there have been no configuration changes on either server.Issue:Calls initiated from Cisco Room Kit...
Hello Everyone,Today I am going through an issue, I have never experienced.We have a CUCM and a 3rd party PBX, we have connected both the PBXs over a SIP trunk.I have created an Extension 2045 in the 3rd Party PBX and created a route pattern with th...
Hi All, I am recently started trying the automations with AXL and Python.Now I have encountered an issue.I am trying to add / Update a phone with two Directory Number, but when I am running the script it only adds one DN.The last specified index is ...
Hi All,We have a MGCP gateway with a T1 trunk, Sometime the outbound calls will stop working and the incoming will work the same time. when we are dialing the digits we are getting fast busy tone. If we reset the MGCP gateway from CUCM, it will start...
Hi All,We do have a Cisco Router, in which we are getting high Temperature alert from Solarwinds while I am checking it's showing temperature is normal with "show environment" but as per the documentation the normal operating temperature is -32° to 1...
Hi everyone,Thank you all for your responses and suggestions in helping troubleshoot the issue.The root cause turned out to be a misconfiguration on the third-party PBX.Our cluster consists of one Publisher and one Subscriber. Initially, the trunk fr...
Hi Nithin,SIP trunk is in full service, Initially they haven't added inbound route but Now they setup the routes. As you mentioned here also they can make calls to CUCM, Vice versa not so everyone is suspecting issue occurring at CUCM end.I tried co...
Thanks Nithin for clarifying about time slot,FYI; As of now I have reset the gateway and calls are working, but from my last 1 week experience on this issue, it will go down in few hours.Update : Now again outbound calls are not working. But incoming...
