Hi This is a case of a company with 3 branches. Two of these braches are connected with dark fiber.The network admin didn't prefer to use VPN IPSEC to connect the branches each other.He preferred to use dark fiber.If I design by Packet tracer two rou...
Hi
I got a question about netacad courses. I don't know if this question can be answered by this forum.
I've taken and passed the courses CCNA 1 v6 CCNA 2 v6 and I'm taking CCNA 2 v7 in Institute A. Then, in another institute I'm signed in CCNA 3...
Hi. I attached the zipped Packet Tracer topology.I can't ping from PC0 to Switch (SW2). It says it's unreachable. I configured the IP address 172.10.99.56 on interface Vlan 99 with ip default-gateway 172.10.99.1. The ip gateway is also configured on ...
He ingresado a netacad el día de hoy y he podido ver que ahora figura CCNA 3 v7. Imagino que debió haber sido un error del Instituto. Me había llamado la atención lo que dijo el profesor. Lo bueno es que lo solucionaron.
Ok I'm giving you the output for vlan 99 using show ip interface brief on SW2 Interface IP-Address OK? Method Status ProtocolVlan99 172.17.99.56 YES manual up down
I'm using Packet Tracer 7.3.0. I set on fa0/1 and fa0/3 ports from SW1 and SW 2 by entering switch trunk native vlan 99. Also I tried the configuration shows like you've shown in previuos post but it didn't work. I could ping from PC 0 to SW1 but I c...
Vlan 99 it's a native vlan I set on fa0/1 and fa0/3 ports from SW1 and SW 2 by switch trunk native vlan 99 On SW 2: Switch#sh interfaces trunkPort Mode Encapsulation Status Native vlanFa0/1 on 802.1q trunking 99Fa0/3 on ...