Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
has anyone succesfully connected a nokia e-series phone to CCM 4.1 or 5.0? as I understand it is supposed to be configured as a 7940 on the CCM, but am not sure what configuration is needed on the nokia e-series phone.also has anyone configured the I...
I have noticed that the latest version of the Cisco IPsec VPN client. blocks incoming packets. for example PPTP doesn't work when the cisco Ipsec client 4.8.01.0300 is installed on a windows XP machineHowever when the Cisco VPN service is stoped the ...
after upgrading to 4.1.3 **#** is not rebooting the phones it goes through the dial plan and the digits failon 7912 we get a promt to click "yes" to reboot
when tryin to load SDM or a routeri get this error"RPC is denied thought the connected interface update cannot proceed" this is after the correcte authentication to the devices and selecting the SDM(or SDM express) to be loadedwhen tryin to use the P...
give desing ? where is the pix in the picture? where are the 2600 basically glbp works with loadbalancing gateways based on the PCs Mac addresses, therefore your 2600 have to be the GLBP default gateway of your PCs. If you have your PCs behind anothe...
thanks I confirmed that with cisco,failover time though has to be worst than static routes, theoreticall, cause ispf neighouring and Topology build have to build again
Thanks I have allready seen the document about Ethernet redancancy. The thing that is not clear in the document,does DLSW ethernet redundancy address the problem in figure 2 about creating a loop?thanks
