Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have 100+ 3750's that are running various IOS, some stacked and some not, and all seem to have the same problem.If I attempt to paste a configuration into the terminal session I get booted after about 10 to 15 lines. This happens when using SSH an...
I'm trying to confirm what a show run on these devices look like with the TwinGig module installed versus without. I need to write configs for the devices but do not physically have them available to confirm how the TwinGig shows up in the config.35...
In CME, is there a way to see when the last time an ephone was registered, besides logging the events? Doing a quick audit of remote IP Communicators.Thanks.
Is there a way to policy route traffic sourced at the router?I have a router that has a second connection to the Internet and is acting as a SIP gateway (CME) and I'd like to force VoIP traffic sourced at the router out the second connection.Data wil...
To the originial poster...The DNS SRV record will be created on the DNS server, not the under the dial-peer or sip-ua. If the router is also acting as the DNS server, in that case the SRV record will be created on the router, but under the DNS serve...
Use CLI until 3.2.2 CCA is released. The IOS in the current software pack supports the 514's, but the CCA is lagging.We have about 70 514's running on a UC560 with no issues.Cisco may take issue and call it an unsupported deployment, but if you need...
