05-06-2005 06:37 AM
Hi all,
I've got a 2610 running 12.2(28a) IP PLUS. It have a NM-2V with one FXO and one FXS card. I've read through alot of imformation now saying caller-id shoule be available on the FXO (I'm running H.323) but the command 'caller-id enable' is not available in global config or on the FXO Voice-port!!
It does appear under the FXS voice port but I don't need it there. Any ideas?
Cheers,
Greg.
!
voice-port 1/0/0
cptone AU
timeouts call-disconnect 5
timeouts wait-release 5
connection plar opx 2000
!
voice-port 1/0/1
cptone AU
!
voice-port 1/1/0
cptone AU
caller-id enable
!
voice-port 1/1/1
cptone AU
!
dial-peer cor custom
!
!
!
dial-peer voice 201 voip
destination-pattern 2000
voice-class codec 1
session target ipv4:172.16.2.100
dtmf-relay h245-alphanumeric
!
dial-peer voice 101 pots
destination-pattern 9T
port 1/0/0
!
2600(config)#caller-id ?
% Unrecognized command
2600(config)#caller-id
2600(config)#voice-port 1/0/0
2600(config-voiceport)#caller-id ?
% Unrecognized command
2600(config-voiceport)#caller-id
Solved! Go to Solution.
05-06-2005 08:19 PM
Caller ID:
Requires VIC-2FXO-M1, VIC-2FXO-M2, VIC-4FXO-M1, VIC2-2FXO, VIC2-4FXO, or MRP3-8FXOM1
http://www.cisco.com/en/US/products/hw/routers/ps274/products_tech_note09186a00800b53c7.shtml
05-06-2005 08:19 PM
Caller ID:
Requires VIC-2FXO-M1, VIC-2FXO-M2, VIC-4FXO-M1, VIC2-2FXO, VIC2-4FXO, or MRP3-8FXOM1
http://www.cisco.com/en/US/products/hw/routers/ps274/products_tech_note09186a00800b53c7.shtml
05-07-2005 05:27 AM
Thanks for that. There are so many documents on CCO with conflicting information it's hard to go through the all!.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide