Hi all,
I've got a 2610 running 12.2(28a) IP PLUS. It have a NM-2V with one FXO and one FXS card. I've read through alot of imformation now saying caller-id shoule be available on the FXO (I'm running H.323) but the command 'caller-id enable' is not available in global config or on the FXO Voice-port!!
It does appear under the FXS voice port but I don't need it there. Any ideas?
Cheers,
Greg.
!
voice-port 1/0/0
cptone AU
timeouts call-disconnect 5
timeouts wait-release 5
connection plar opx 2000
!
voice-port 1/0/1
cptone AU
!
voice-port 1/1/0
cptone AU
caller-id enable
!
voice-port 1/1/1
cptone AU
!
dial-peer cor custom
!
!
!
dial-peer voice 201 voip
destination-pattern 2000
voice-class codec 1
session target ipv4:172.16.2.100
dtmf-relay h245-alphanumeric
!
dial-peer voice 101 pots
destination-pattern 9T
port 1/0/0
!
2600(config)#caller-id ?
% Unrecognized command
2600(config)#caller-id
2600(config)#voice-port 1/0/0
2600(config-voiceport)#caller-id ?
% Unrecognized command
2600(config-voiceport)#caller-id
