10-04-2005 10:36 AM
Is there a command out there to reset/disconnect an FXO port after a certain time period?
Our paging system is connected via FXO, and sometimes the port gets hung. SInce I don't want to be called in at 3AM, is there any advice out there?
Thanks in advance...
10-09-2005 08:02 PM
Hi,
This is classic case of FXO disconnect issues. This primarily seen in Loop start configurations. The below link can help fix the issue.
http://www.cisco.com/en/US/partner/tech/tk652/tk653/technologies_tech_note09186a00800ae2d1.shtml
Hope it answers your questions.
Thanks
Venky
10-27-2005 05:32 PM
Hi,
I had the same issue and I did apply a tcl script on the dial-peer tp disconnect after a maximum period of time.
PL
11-01-2005 07:53 AM
where can I snag that script?
04-26-2006 02:29 PM
Hi Pierre
Any chance having a look at your TCL script?
Cheers
Andy
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide