I'm fairly new to CUCM and was looking for some guidance. I recently inherited CUCM 10 and have gotten the basics down, but am still learning the rest.
There is an external 1(877) number (OpenVoice Conference Number), and is the only 877 number we cannot call. When we dial it, there is only silence and then the call automatically ends. I am able to call the number from my cell phone, so I know it's a working number. Here is the list of our call routes for 18XX numbers.
As you can see, there are some routes that are made to refuse the call. I made a route that is specified for the number (See "Conference Call Number" in the picture), and am still not being put through. But when I dial other 877 numbers, I have no issue.
I tried to use DNA, and although I'm not entirely sure that I am putting the information in correctly, these were the results:
I've contacted our phone service provider and opened a ticket with them to make sure that the number isn't dropping on their end.
Any help would be greatly appreciated as I'm a little lost on what I could be doing to fix this.
This document summarises various health checks that can be done on a Cisco VIM pod.
Cloud sanity checks the health status of network, storage and various openstack infrastructure components like mariadb, rabbitmq etc....
The following pre-requisites are necessary for the migration from RSP440 to RSP880-LT to be successful.
Make sure that you have console access to the router.
Verify that the system is running a minimum o...
BGP flowspec in a nutshell is a feature that will allow you to receive IPv4/IPv6 traffic flow specification (source X, destination Y, protocol UDP, source port A .. etc) and actions that need to be taken on that traffic (...
While gNMI is fairly new, it's becoming more and more powerful. Its abilities to simplify network management by the use of protocol buffer files and standard definitions are enabling our customers to integrate a lot ...
Today we are releasing to the public a tool to help find differences in command outputs in two points in time (IE pre and post MW).
The issues we are addressing is what commands to gather and how to successfully parse the data when timestamps, upti...