Voice Systems and Accessories - Small Business

Have a SPA525G2 phone that lost connectivity.  Discovered thru the network status page it did not have an IP address assigned. Hardware troubleshooting already performed includes: swapping out Ethernet cable, tried different port on switch, tested on...

I have a UC320w with SPA504G handsets.  I've been trying to reset the date and time and have been unable to do so.I have access the my UC and access to the handset but am still unable to set the date and time. I read during  my research on this, that...

Can someone please tell me what the differences between these two commands are: service phone daysBacklightNotActive 1service phone daysDisplayNotActive 1 We have 7945 and 7965 model phones.  What will the effect be using one or the other of these co...

Hello. I am having a great deal of trouble configuring my SPA 3102 to forward PSTN calls from a specific phone number to a my VoIP phone number while ignoring all other callers and would appreciate help fixing the issue. My first attempt to set this...

UC560 Users dial a "7" then 1+10 or just 10 digits. I'm getting carrier message "the number cannot be completed as dialed..." with the following config below. When I put an analog phone right on the POTS line I'm able to dial out successfully using 1...

I'm unable to send calls to my carrier on POTS lines plugged into the FXO ports. When I dial 7+1+10 I get "that number is not in service..." from the carrier. According to my translation rule I should be sending 1+10. When I plug an analog phone into...

Group,I came across some unexpected behavior yesterday I was wondering if someone could help shed some light on the problem. In my DNS I created this record: _sip._upd.platautofinance.com which when I do a query using MX Toolbox it is correctly repor...

Hello,I bought a spa122 and several spa112's for replacing ata's in the field.Is it possible in these devices to use the following parts in a dialplan.Example 1:*1xxxxxxxxxx<:@fwdnat.pulver.com:5082;uid=jsmith;pwd=xyzExample 2:*1xxxxxxxxxx<:@fwd.pulv...

I have problems sending notify to our Cisco phone with the new PJSip driver from Asterisk.I had no problem before with Chansip. I have submitted the problem to the Asterisk team but I still cannot find what the problem is.I can reboot a yealink phone...

I've just purchase a Cisco ATA, SPA 122.I can't get the Admin page up when I input the IP address of the ATA.Browser is Safari. Any help greatly appreciated. Cam.