Buy or Renew
Buy or Renew
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
525
Views
0
Helpful
1
Replies

Inbound Callerid

Go to solution
Joseph Chambers
Beginner
Beginner

‎11-29-2010 10:31 AM - edited ‎03-21-2019 03:19 AM

504G phones - UC560 - 8.0.2 - PRI

During inbound calls, they can see the phone # until they answer, then they can only see caller-id name for the connected call.

Is there a way to only show the phone #?

Labels:
0 Helpful
1 Accepted Solution

Accepted Solutions

Go to solution
Nathan Compton
Enthusiast
Enthusiast

‎12-01-2010 04:46 AM

You can turn off Caller ID name in the incoming dial-peer:

dial-peer voice 1 pots

     clid strip name

Adam Compton

View solution in original post

0 Helpful
1 Reply 1

Go to solution
Nathan Compton
Enthusiast
Enthusiast

‎12-01-2010 04:46 AM

You can turn off Caller ID name in the incoming dial-peer:

dial-peer voice 1 pots

     clid strip name

Adam Compton

0 Helpful
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Recognize Your Peers
Spotlight Award Nomination
Customers Also Viewed These Support Documents