REDIRECT CALLS THAT INCOMING OF NUMBER DID TO EXTENSION

[Israel Vargas]

Hi I need help.

I have a group of DID's numbers (of 12534000 to 12534049), i want redirect calls that incomig of DID's to the specific extension, for example:

I call to the number 12534000 then this call send to the extension 101 or.

I call to the number 12534049 then this call send to the extension 110.

I have this configuration:

voice translation-rule 1

rule 1 /4000/ /101/

rule 2 /4049/ /110/

voice translation-profile INCOMING-DIDS

translate called 1

voice-port 0/2/0:0

translation-profile incoming INCOMING-DIDS

dial-peer voice 100 pots

description ** incoming dial peer**

translation-profile incoming INCOMING-DIDS

incoming called-number ^AAAA$

port 0/2/0:0

dial-peer voice 6 pots

description "catch all dial peer for BRI/PRI"

translation-profile incoming INCOMING-DIDS

incoming called number .%

direct-inward-dial

When the call comes don't send the call to the extension.

thanks I hop can you help me.

[Israel Vargas]

Sorry.

The above is in the UC540 equipment.

[janickle]

Hi Israel,

Where do you want to forward the calls to once the DID comes inbound?  If you just want to stop them remove or modify the voice translation rule.

Jason Nickle

[Israel Vargas]

Thanks Jason.

That is correct, i want to forward the calls comes inbound to a specific extension, I modify the voice translation rule, but no call comes, good, call come to the trunk, but don't know where to send it, I just know if my configuration is correct or i missing something.

[Naum Vitanovski]

Hi Israel,

You should use CCA to configure inbound did to go to a specific extension.

Go to Configure -> Telephony -> Dial Plan -> Incoming

Then in your Inbound Trunk Settings, specify the range of numbers and the appropriate extensions range. e.g.

12534000 to 12534049 go to extensions 200 -249

also if you do not specifiy this whole range, you can go for specific did: 12534000 to (same number) 125340000 to Operator and write the extension number there.

I think you add this in the bottom square, by pressing the Add button.

Hope it helps