Voice Systems and Accessories - Small Business

This defect (CDR record parsing error) was mentioned in another thread. (I didn't want to hijack that thread with this)Would it be possible to get more information?Has this been acknowledged/confirmed as an actual bug by Cisco?Is there a resolution t...

Hi All,I have a UC540 that has stored "stock" images on the flash (ie. tftp-server flash:/Desktops/xxxx.png).In CCA, I can see the actual pictures when I select the Telephony > Phone Customization > Backgrounds. On the SPA525G sets, I'm unable to sel...

Hi I have a remote site with 4 IP phones registered to CUCM ver7. I also have an analog PSTN line at this site. I want to connect this PSTN line to the network and use it as a gateway. I am looking at buying a SPA3102 to do this. Can anyone tell me i...

hi team we are looking for a system that support multiple music sources for call queuing, We are planning to provide the listen live music via dial a local phones numbers and we wat to sell this service to multiple radio stations, so one or two music...

Hello,if i receive or make a external call i cannot transfer the call to any ip phone im using uc540 en 12 phones and no one works, i create new template and using the existing default templates and the transfer button does not appear in the ip phone...

    ------My Cisco Reboots daily during business hours. Can I set a 3am reboot?Below is my .cfg for my phoneI am not sure which setting is causing the phone to reboot.Any one have any good config files that dont cause teh phone to reboot when it does...

Hi, I have a customer that has 2 x UC500 installed at separate sites. They are considering using VT Advantage between these sites with the individual phones being registered with the local UC500. Will VT Advantage work between the 2  sites as it woul...

Hello,We have 2 x SAP510g phones.  First phone was working fine, as soon as we connected the second unit both phones cannot see the network.  We are using a basic TP Link PoE switch.  Connected the good phone via a PoE injector, stilll no luck, canno...

I am setting up a 7960 phone for extension mobility. I would like to add a dialable intercom button to the phone profile for when no one is logged in and to the user profiles for each repective user.However, if I change the amount of button to 2 and ...

Am I able to have the Auto attendant answer the calls first when I am in key mode?Thanks in advance!

HelloSome questionOn the UC500 serie's there is een "EXPANSION" portHow the configure best ?I have in my network a few SLM2008 cisco switches with vlan supportI have a SLM2008 in my livingroomone in the storage room (where the UC520 and the cable mod...

Hi,we have a customer without VM because the calls incoming to VM do not finish (... the message has 10 minutes and the UC320 does not hang the FXO Line)The line remains busy until the UC320 is rebooted.Some suggestion for this problem?B.R.Rafa

Not sure if this is even possible to include in a future release, but an anti feedback option for paging would be excellent. There are third party systems to provide this anti feedback page feature, but none of them operate off the 3.5mm page out jac...

                   On asterisk based IP PBX's I can set up a dial out rule to dial straight out instead of having to dial 1 or any other number specified before I dial the phone number, is it possible to do such a thing on the UC320 as it is a pain h...