06-20-2013 02:37 PM - edited 03-21-2019 07:29 AM
Hello everyone.
I have a customer who wants to forward calls to your mobile phone and he want to see in the display mobile the origin calling number .
The ISDN service provider allows this facility.
Anyone know how to do?
Thanks
06-20-2013 04:33 PM
Hello Eduard,
If you are using CCA. Under outgoing dial plan. In the ISDN trunk set the caller id only for internal extension not for any.
If you are using CLI just make sure you have calling number initiator under telephony service and that the rule matching the corresponding dial-peer is set to change only the internal extensions.
HTH,
Alex
*Please rate helpful posts
06-24-2013 11:11 AM
Hi Alexander.
Thanks for your answer but the client wants to see the number of the incoming call initiator.
I have to talk to the service provider to make sure this is allowed.
06-20-2013 09:32 PM
Eduard Trullols Ripolles wrote:
Hello everyone.
I have a customer who wants to forward calls to your mobile phone and he want to see in the display mobile the origin calling number .
The ISDN service provider allows this facility.
Anyone know how to do?
Thanks
You can take "debug isdn q91" with "term mon" to see which calling number is being sent.
However unless you are in the USA, I doubt that telco will actually allow that.
06-24-2013 11:18 AM
Hi Paolo.
I'm in Spain, but I have to speak directly to the service provider because the customer is who they say that if allowed but I have my doubts.
Thanks for your answer.
06-24-2013 11:21 AM
You can check, but is not allowed for sure.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide