I have just installed a Cisco UC540 and connected both in and outbound VoIP lines with VoIP.MS the issue that I keep running into is the inbound calls stop or do not get routed?The system will work perfect until no outbound or in bound calls are made...
Hi All,I'm currently (pain-stakingly) trying to do what should be a simple task of upgrading a number of 7945's on a UC520.CCA is 3.3.2 and the UC520 on 8.6.The 7945's are on 8.3.2, Im trying to go to 8.5.2.Any attempt to drag and drop results in the...
Hi - we have a client that uses the call park feature and paging feature of the Cisco UC560. If a user is paging all phones and at the same time, a different user parks a call, there is a slight interruption in the paging system.Is there any way arou...
Hi - I have an SPA 504G with SIP service and use a third party conference service to host conference call. The 3rd party service requires me to log in as the Leader and to do this I have to press the * key. This doesn't work possibly becuse * has ...
SPA232D is declared to be DECT base station. Unfortunately, I found no information about exact DECT profile implemented in SPA232D. The question is obvious. Is it a proprietary profile DECT base station, so the SPA302D is the only terminal that can b...
Hi, I am opening a mid sized retail shop. I have (2) 7970, (4) 7940, and (1) 7925. I need 1 auto antendant menu (when call comes in via fxo line), 1 FXO Line for in/out bound calling, and 1 voice mailbox that sits on an extension. Would it be possibl...
I have a system in Key Mode, and cannot seem to figure out how to get an analog phone that's plugged into the FXS Port to make an outgoing call.
I have completed initialized and configured first E1 interface, but can not find the second E1 interface in the GUI.Can you help me？thanks.
Hello all,Has any one had issues or success upgrading the firmware of a SPA122 remotely?I have the parameters set the same way as my 2102's and I do not seem to get my device to pull the firmware.Any thoughts?
Has anyone successfully installed and configured the Linux Version of Provisioning manager that came with the BE6000 8.6 bundle?I can get the IP/Network config done using the Quick Start Guide, but then the guide references logging in with admin, and...
Hi,We just purchased an SPA112 unit for testing before a large deployment.There's a working provisioning setup in place for SPA303 devices using DHCP option 66 with an https URL. The provisioning of SPA303 phones wokrs just fine, SPA112 on the other ...
I have this ugly issue where I have 3 pots lines from Verizon going into a UC320W and when my client makes outbound calls sometimes while dialing the phone just drops ... and the phone display goes back to the main screenI got some logs (other than s...
Hello All,My UC520 issues continue. After much frustration and assistance I finally got my SIP trunk running and all appeared to be well. Calls and DDI's were working great. I though job done. However, another issue has popped up.One of the staff ...
Anyone having issues with CWID on the SPA122? The call-waiting call beeps but doesn't show the caller ID name or number. I'm running the newest firmware 1.2.1-004. I've seen complaints about general caller ID issues with the older firmware but not wi...
Hello, I have to configure "Fax 2 email" in a UC540 and I have no experience.The connection of the fax machine is on FXS ports.The email account is a gmail.I just need to set the incoming fax to gmail account.Someone has configuration information.Tha...
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: