11-23-2012 07:53 AM - edited 03-21-2019 06:38 AM
Hi
when I deploy my phone in a car dealer shop, all phones working well except one spa 512 not working with uc320, when i connected it to sge 1020p sw, it powered up and after a while, it display "initializing network" and dead there, not going to the rest process such as go search DNS, and synchronizing.... and all the keys of the phone are dead, so I can not change it to the default factory setup. i tried the manu key all the time when it power up, but it alway locked. so how can I do with this phone?
Thanks in Advance
Rex.
11-25-2012 03:16 AM
Hi Rex,
Are the other phones connected to the SGE2010? If it’s the older version with the Linksys logo it does not support CDP or LLDP. One of these discovery protocols are needed for the phone to register to the UC.
It is still possible to register the phones through the SGE through a pmf that can be installed on the UC320W. Just make sure you have your switch properly configured with VLAN 1 and 100 and a trunk port going back to the UC320W. Then follow the directions from this link.
https://supportforums.cisco.com/thread/2104631
If you have further questions let me know.
Thank you,
Jason Nickle
11-25-2012 08:22 AM
To add to Jason's post, ensure the port of the switch connecting to the phone has port fast enabled, otherwise the phone will boot loop/lock symptom as well.
-Tom
Please rate helpful posts
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide