Voice Systems and Accessories - Small Business

Hi,Have an issue that I can't fin the reason for.We have 10 spa942 phones.Some time the phones sending a bye message directly after you have answer the call.It happens approx 5 of 100 incoming calls.Has someone any clue why?Could it be any parameters...

Tengo un Cisco IP Phone Spa 525g y cuando trato de conectarme a un VPN me sale el siguiente mensaje: "Failed to obtain WebVPN cookie".Tengo instalado el último firmware.¿Alguna ayuda?                   Gracias.------I have a Cisco IP Phone Spa 525g. ...

I have a few Cisco 525G2's all flashed with and running 7.5.2a firmware (a-bt).After switching on the screensaver option then choosing the clock as my screensaver oh and settting the trigger interval at 120 (have tried 30 and 300 too) upon saving the...

Dear all,I have configured two schedules in UC560 using CCA 3.0.1 (office_hours and break_time).  I have then configured two auto-attendants. AA1 is used for office_hours and AA2 for break_time.  AA1 is working fine.  However, when it is break time, ...

I have a customer who when I log into the web GUI over the WAN connection, I get the "you have been disconnected" popups... the connection seems to come back within a few seconds though.At this point we suspect that the issue is with the carrier (we ...

Hi,Am I correct in assuming that the option to disable the DND feature via the 303 phone management page is removed when connected to a UC320W as it manages the phone config? BUT there is then no way in the UC320W to manage the phones in this regard?...

Ladies and gentlemen,I'm in the middle of my first UC320W install this week.  It's a greyfield scenario where the client has a Westell DSL router that both terminates the DSL connection and also provides the office Internet access via WLAN.My plan (a...

We have a specially provided pstn connected to an fxo port on a UC320W. Because I cannot have more than one fxo trunk, I have provided this pstn as a shared fxo and thus each of the member handsets has a key to access it. This works. BUT the number o...

I have remote users with 525g2s configured with webvpn.  The phones connect successfully to an ASA5505.  The phones register successfully with a uc540 behind the ASA5505.  The remote phones can access voicemail, can make outbound calls, and receive c...

Hello,I  used to install the SPA-2102 ATAs at my customers sites (POS) in a very  fast and reliably way by using the following procedure:Connect 'Internet' socket (to LAN), phone and powerGot to IVR (****)Enable WAN Admin Support by entering 7932#1#1...

Looking for a Video solution for UC500. The CUVA goes EoS in October and the replacemant is Jabber for Windows. Has anyone an experience if Jabber works with UC500 as well?Thanks for your HelpFrank