12-21-2009 10:20 AM - edited 03-21-2019 01:57 AM
Hi,
It's possible to configura a line key 1 with an extended function like
fnc=blf+sd+cp;sub=200@172.18.20.22;nme=Ext 200
in order to monitor the extension 200 without an attendant Console?
I did it on an spa942 and spa962 but i don't know if it's possible on a SPA5XX
Thanks in advance
12-21-2009 10:32 AM
Dear Sir;
Yes, it is possible.
Regards
Alberto
12-21-2009 10:54 AM
I try it, but the led is all the time orange.
My Configuration is:
Extension: Disabled
Share Call Appearance: Shared
Extended Function: fnc=blf+sd+cp;sub=200@172.18.20.22;nme=Ext 200
Short Name: 200
Server Type: Asterisk
The Call Pickup and BLF doesn't work Speed Dial Works fine
Can you help me?
12-21-2009 03:12 PM
Hi cinglalls,
At asterisk's CLI, type: core show hints
This will tell you who is watching what
Verify that you've a hint in the extensions.conf file.
Example:
SPA509 has the following configuration to subscribe and monitor extension 508:
fnc=blf+sd+cp;sub=508@192.168.2.245;nme=508
The extensions.conf has the following:
exten => 508,1,Dial(SIP/508,10,rT) ;ring for 10 seconds
exten => 508,hint,SIP/508 ; hint: core show hints *CLI sees extension state
exten => 508,2,VoiceMail(508@default,u)
exten => 508,3,hangup
exten => 9508,1,VoiceMailMain(508) ;mailbox access for extension
Make sure that the sip.conf allows your phone to subscribe to extension 200's state. Continuing my example, sip.conf snippet:
; allow phone to subscribe to another phone's extension state
allowsubscribe=yes
notifyringing=yes
limitonpeer=yes
notifyhold=yes
;
Regards,
Patrick
----------
01-04-2010 09:57 AM
Hi,
I put the other unused extensions to disabled and it works.
Thank's for your help.
03-04-2010 04:39 AM
Hi,
I have a SPA504G and I'm trying to configure BLF with Elastix 1.6.
I can make a speed dial but the ligth is off.
08-12-2010 11:24 AM
FYI, I had the same type of problem (getting the last 4 line keys to be BLF+SD on a SPA509G), and disabling the unused lines did not help. It turned out the attendant console units were enabled in the config, but I did not have any SPA500S units attached. Disabling the two consoles in the config made BLF on the line keys work again.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide