12-07-2012 01:07 PM - last edited on 03-25-2019 11:04 PM by ciscomoderator
Hi, uc540 + 4port fxo card, 8.6.1. I have three different companies on a uc540.. ext 200-219 is one company (A), 220-239 is company B, and 240-259 is company C.
Company A owns POTS lines 1-3, Company B owns POTS lines 4-6, Company C owns POTS lines 7-8
I want any calls from extensions for company A to go out 1-3 in any order, I want company B to go out 4-6 and company C to go out lines 7-8
Is there a way to do this without different access codes? Meaning i'd rather not have one company dial 6 before making a call, the second company dial 7 and the final company dialing 8..
for example, possible to setup fxo 1,2,3 into one trunk group and assign a group of extensions (or by ext/phone specifically) to use that fxo trunk group for outbound calls?
thx
12-07-2012 01:30 PM
Yes, you can use a COR config. There are many threads about that either here on in "IP telephony" forum, for that you can use the search box on the top right.
12-07-2012 02:52 PM
thanks i'll take a look again.. i searched for about 45 minutes, but only could find an example where an extension was assigned to a specific fxo port .. one to one type of thing..
12-08-2012 07:52 AM
excellent example in case someone checks this thread-
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide