08-09-2010 01:20 PM - edited 03-21-2019 02:50 AM
Hi,
At a customer site I have installed an UC540 with one dualline isdn2 trunk and a SIP trunk configured. Incoming phonecalls are handled correctly. In my config outgoing phonecalls depend on the priority of the dial-peer (sip or pstn) whether the phonecals go out via SIP or pstn.
Is there a way to route one ephone through the SIP trunk and an other through ISDN? (CCA or CLI)
Kind regards,
DimiW
08-09-2010 01:23 PM
Corlists, but not supported by CCA.The Cisco Press Voice Gateways and Gatekeepers book does a good job explaining it.
--
Anthony Yeung
Technical Marketing Engineer
Small Business Technolog Group
08-10-2010 03:18 AM
Thanks for the response.
Does this mean that in the next release of CME v8.1 where multiple SIP trunks are supported I have to configure outgoing calls with corlists similar as you discribed in your reply? Or will there be support for that in CCA?
Kind regards,
DimiW
08-10-2010 03:26 AM
I did see that multiple SIP trunk configuration is on the roadmap for CCA. I don't have an exact date of implementation but it is on the list.
I will forward this thread to the PM.
Steve DiStefano
Technology Solutions Architect - Partner Sales
Cisco Systems
Research Triangle Park
North Carolina, U.S.A
1.919.392.6219
www.cisco.com/smb
08-10-2010 10:40 AM
Support for Multiple SIP Trunk Providers is planned for the Q2CY2011 release of CCA.
08-10-2010 08:46 AM
Here's one way to do this. The following link refers specifically to FXS/FXO ports, but the concept can be applied in your scenario.
http://www.cisco.com/en/US/tech/tk652/tk90/technologies_configuration_example09186a00801bc341.shtml
Hope this helps.
Brandon
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide