01-04-2012 02:38 PM - edited 03-21-2019 05:09 AM
Hello,
Can anyone help me configure Cisco IP Conference Phone 7937G with UC560. Is there any special steps to perform for configuration or just as a normal Cisco IP phone connect directly to the router, assign extension using CCA and it will start working?
Do I need to perform additional steps to configure this conference phone like registering it with TAPS? How can I activate the conference phone and how can I get the TAPS extension to activate it?
Thank you for your time and consideration.
Veeral
01-05-2012 12:09 AM
Should be the same as configuring any other phone. I have seen issues with using non US locale and the phone failing to register so if you are not in the US and you have a non US locale configured switch to US to test.
01-05-2012 07:43 AM
Thank you Craig for helping me out. I appreciate it. I will be using USlocale since this installation is in US.
Again thank you for your help.
Veeral
01-05-2012 06:43 PM
Hi Veeral,
Please ensure the following:
This should cover the setup, the rest can be achieved on the system itself not so much the phone
Cheers,
David.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide