UC560 Forced Authorization Codes (FAC)

[adrian.meighoo]

Hi All,

Has anyone gotten FAC to work with the UC560? The box only crashing when the voip is enabled. When i shutdown the voip it makes the calls successfully.

can help is greatly appreciated

here is the configuration

Place the files in flash enter_account.au and enter_pin.au

aaa authentication login default local

aaa authentication login sdm_vpn_xauth_ml_1 local

aaa authentication login h323 local

aaa authorization exec default local

aaa authorization exec h323 local

aaa authorization network sdm_vpn_group_ml_1 local

aaa authorization network h323 local

application

service clid_authen_collect

  param uid-len 3

  param pin-len 6

dial-peer voice 50 voip

service clid_authen_collect

destination-pattern 9[2-8]......

session target ipv4:192.168.20.1

incoming called-number 9[2-8]......

dtmf-relay h245-alphanumeric

codec g711ulaw

no vad

dial-peer voice 100 pots

destination-pattern 9[2-8]......

preference 1

port 0/1/0

forward-digits 7

[Alberto Montilla]

Hi Andrian;

Please stay tuned for help. I will ask a colleague to give you a hand on this.

Regards
Alberto

[Darren DeCroock]

Hello Andrian,

There are a few things I noticed, not sure if they are just left out, or not configured.

Your config does not have any usernames/passwords configured, and the dial-peer is pointing to the CME address.  Here is the info I found, with the steps to configure FAC.

https://supportforums.cisco.com/docs/DOC-9795/

application
service clid_authen_collect
  param uid-len 3
  param pin-len 3

aaa new-model
aaa authentication login h323 local
aaa authorization exec h323 local
aaa authorization network h323 local
username 201 password 123
username 201 autocommand exit
username 202 password 321
username 202 autocommand exit

dial-peer voice 5500 voip
description International Calls
service clid_authen_collect
destination-pattern 9011.T
session target ipv4:10.1.1.1
incoming called-number 9011.T
dtmf-relay h245-alphanumeric
codec g711ulaw
no vad

Thank you,

Darren

[adrian.meighoo]

Hi

I have the username and password in the configuration and also i've configure 192.168.20.1 as the cme ip address.

[Alan Daniel Chavira Rodriguez]

could you solve it? I have the same problem

Best Regards

[chris henderson]

hello  Alan,

     got the issue fixed . you need to upgrade the uc560 version to 8.6 .

regards

Chris Henderson

[Alan Daniel Chavira Rodriguez]

Well the most recent is the 8.2

Thanks, let me try

best regards

[chris henderson]

hello Alan ,

          following up to see if you got the issue resolved ?

Regards

Chris Henderson

[Alan Daniel Chavira Rodriguez]

hello Chris,

I could resolve it thanks, in my case it was problem with the configuration.

best regards

[Erik Antonio Lara Gonzalez]

Excuse me, what was your configuration error?

[Alan Daniel Chavira Rodriguez]

Hello Erick,

I do not remember, but works when apply a Factory Reset and reapply the configuration.

Best Regards

[Erik Antonio Lara Gonzalez]

hahaha i think the last resource always works (reseting the device). I did that on our 3825 and FACs works well.

Regards,

[Alan Daniel Chavira Rodriguez]

nice hear that,

Best Regards