Hello,Is there an option to enable a subtle beep when putting the phone on mute. Especially when walking away from the phone with a headset it would be helpful to have the phone signalize that I am still on mute.
Hi, Sorry to re-post.. I just think that the title of my previous post is not correct and I made some progress....I am using a SPA8800 as a gateway, connected to an Asterisk server.I am sure that the PSTN line send the CID of the caller....On the SPA...
Hey AllWe have a small office that recenly implemented a UC540 and all 7975g IP Phones. What I am wondering is this, is it possible to configure these phones to run as a VPN phone so we can have a couple at other small location offices we have with w...
The time on the phones are different then the time on the system. How do we force a sync?Here is the time on the phoneScreenshot below of system timeThe system has been rebooted twice and still no resolution.
Hi all,I am trying to establish site 2 site vpn ipsec tunnel with srp521W with dynamic public ip on one site and UC560 with static public address on other. So far i sucseded in establishin tunnel witch i verify on both sides, but i could not get traf...
Hi,Can we block to access to call manager (CUCM) from some untrusted PC through call manager level itself inspite of Firewall ,router or switches Best RegardsVishal M
When configuring sites for the BE3000, it is possible to define a local area code. This creates entries in the dial plan that allow users to just dial a local number with the system automatically adding the area code.Currently (as of version 8.6.4) ...
Hi all,I am trying to do my own dial plan patterns because I am in Spain and there are not patterns preconfigured for Spain.I have a SIP trunk into PSTN Connection.The device is a C2901 configured as CUBEFor my test I want to use a custom dial plan s...
Hello,We have one question: Is it possible restarting a XML service from an IP phone after error "ERROR XML 4” appears on the display? How could we make it?Regards,EDIT: We have a service based on XML running on Cisco 7975 phones. This service works ...
We're evaluating SPA504G phones (and their brothers) as replacements for our current best-sellers. I've managed to iron out all of the bugs and troubles, save one.If I watch my SIP packets, I see that a blind XFER to our park server (*77) sends out t...
here's my setupuc540 (192.168.0.96) used by wan port in 192.168.0.0 network192.168.10.0 network connected through a vpn tunnel to 192.168.0.0 networkphone and data in same network in both networks (192.168.0.0 and 192.168.10.0)When people speaks toge...
Hello all,So I've installed a new UC320W at a client site, I must say I am new to this product, more used to UC500 products, but seems like it is a good product (or will be!)Only problem right now is that during the test I had recorded an invite sayi...
Customer has valid ESW/UCSS contracts on CUCM-UWL-BE. In following the ordering guide the starter bundle makes sense but the 9x3 migration does not. Being new to Cisco products, it was my understanding that those contracts would allow them to migr...
Good day everyone! I’d like to share my experience with UC560 to see if somebody had similar problems. We’ve been using UC560 with 10 SIP trunks for 2.5 years. Previously UC560 WAN was plugged directly into our router and had a Public IP. Because of ...
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: