UC560, SR520 Teleworker and VG202

[graeme]

Hi There,

We have requirement to provide an analogue fax line in a client that has a UC560 at Head Office, a leased line to a sattlite office, and 6 phones setup.

We purchased the VG202, but as its not a CCA configurable device, I have no idea where to start in setting this system up.

Is there anyone who can point me to a document that would explain how this should be configure, what it is setup as on the UCend, and how we route calls to its 2 analogue ports.

Thanks

Graeme

[paolo bevilacqua · Accepted solution]

You can use ether H.323 or SIP, or SCCP on a VG202. Fow example the latter:

http://www.cisco.com/en/US/docs/routers/access/vg202_vg204/software/vg2_vg4_voip_ps2250_TSD_Products_Configuration_Guide_Chapter.html

There is ample documentation for any need if you search or browse cisco.com