Voice Systems and Accessories - Small Business

Hello all,I had an UC520 with one interface BRI configured, with installed a new isdn line and connected it to the second BRI interface, we are receiving 4 calls that shows us that the bri is working, but we are unable to make more than two simultane...

I have a UC320 with SPA 502g phones and Cisco SF 300 10/100 Switch.We are set up with several users plugging thier workstations into the SPA502G for network connections - then the SPA502G is connected to the SF 300.Intermittently I get an issue where...

Is there a way for a user to "force night" remotely?

The title sums it up. What I have done so far is this:Cisco SPA9000Static IP: 192.168.1.200Subnet Mask: 255.255.255.0Gateway: 192.168.1.1DNS Server: 192.168.1.1Proxy: 192.168.1.201SIP Port: 5060User ID: SPA9000Display Name: SPA9000Password: 12345Auth...

Hi everyone,I have the following issue setting up uc320w. The device is located after router (192.168.1.1) which serves as DHCP for main network. Uc320w has 192.168.101 address as wan,  and manages voice and data in its subnets by default. All device...

Hi There,We have a SR520 Teleworker solution, from a UC560 setup as per Cisco Documentation and was working fully. Main site can ping remote site, and vce versa.Now as of this morning for some reason when you ping the main site4 from remote site it w...

Hi There,Is there any documentation on how to setup a VG202 with a UC560?ThanksGraeme

Good afternoon,I've setup a UC560 for remote admin access via the SSL VPN built in to the UC560. My question is how many incorrect tries does someone have to make before it goes into lock out and how long until it allows login again? Also can this be...

Does anyone knows if there is a way to add FAC to a user on the UC320, or if there is a way to block some patterns like for example 9,01900XXXX, but allow others like 9,01800 xxxx etc.RgdsVicente

Hi all,how can I reserve one of my 4 trunk sip for fax communications with the device connect to the fxs port?For incoming call I can configure the incoming call menu and forward to the fxs port, but for outgoing calls I don't know what I need to do ...