VPN

Hi there, I have an issue where i am unable to route from the hub to the remote site when using FLEXoMPLS,Everything works and the tunnel sets up fine, though the cloned virtual-access interface isn't used in any routing table as a recursive.The rout...

Hi there!I have 2 Cisco SOHO 97. I know they're old, but they works like a champions!I restore the routers to factory config: erase running-config, so, the routers boot with no configuration.Here is the Configuration/scenario I'm planning:RouterA----...

Hi,we have an ASA 5505 base license 50 user v8.4(6) using classic IPsec VPN client. We have been told we need to upgrade the security of the VPN connection to support AES 256 bit encryption, and only accept this level of security, client is not allow...

I have setup Smart Tunnelling on an ASA5505.Situation is PC --->  Proxy [bluecoat] ---> Internet ---> ASAI can connect to the front end clientless VPN side ok and I then click on start smart tunnelling.  It starts up (at least it says so) but when I ...

So I have to set up a VPN for the EMS' Trucks. Their IT guy said something's wrong with their IP scheme and I would have to use the MACs when I set the tunnel up.  I have never used MAC addresses to set up a VPN before. What command will be different...

ASA 9.1(1) WebVPN users cannot access Sharepoint 2013 application. They are getting an error message:ASP.NET Ajax client-side framework (ScriptResource.axd) failed to load.The documentation says:Enterprise Applications Supported The ASA 9.0 clientles...

I'm researching a problem we are experiencing with our iPads and Cisco AnyConnect Secure Mobility Client for the iPad. We have the On-Demand VPN feature turned on and it will start a vpn connection from within the Jabber app (although it can be inter...

                   Yesterday, when I attempted to start the AnyConnect Secure Mobility Client to establish a long-working VPN connection, the software failed to automatically install the client (see attached screen capture).  I tried clicking on the ...

I have three sites connected to each other by L2L VPNs - Site1, Site2, Site3.  Each site has its own ASA 5510 and RemoteVPNs have been configured on each as well.My problem - When a remote user connects to Site1, he or she can only access resources t...

Having some trouble connecting to the servers through the ASA 5505 with RDP from the outside network. I can ping the router outside address but i cannot ping any other outside address i assigned to the servers. I've tried different natting conf and r...