VPN

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

Cisco CyberSecurity

Labels

Forum Posts

Hi AllAll sites in the attached diagram are physically in different towns. I plan to have a vpn network between all sites using the ISR's. But on SP premises thinking to put E1 to Ethernet converters . Is it doable and is it worth it ?tnx

sannayev by Level 1
  • 2628 Views
  • 9 replies
  • 0 Helpful votes

Hello,I have a simple question regarding dead peer detection on the ASA 5520.  I am using a cellular VPN device to connect back to an ASA 5520 and I have noticed that the connection drops at random periods during the day.  The vendor for the cellular...

I bought two ASA 5505 Security Adaptive , my mission was to create Vpn REMOTE Access ipsec that i can access through the internet , i can connect through the VPN , but the problem i can't reach my private or inside network of 192 ., i search it , goo...

Hi, I have a Cisco 1760 configured as easy VPN server. Using the cisco VPN  client I can connect to the VPN server. The problem is that there is no  ping between clients. When I connect several clients to the VPN server  there is no ping between the ...

Remote vpn can not access inside user.Hi dears. i configurated remote vpn at asa 5510. i attached my network topology. ip local pool VPNPOOL 192.168.200.1-192.168.200.100.i can access servers with remote vpn which they located at dmz zone at asa(writ...

I want to build up a small network of 3 branches and 1 headoffice . I wanted to use the cheapest and better solution avaliable to I came up with the following part numbers For Headoffice ASA5510-BUN-K9           ASA 5510 Appliance with SW, 5FE,3DES/A...

Hi guys,I am having this invalid SPI error in my IPSEC tunnels everynow and then and i had configured the spi recovery in the routers.Usually the tunnels will flat and within a minute or so it will recovered as the recovery kicks in.....But what i wa...

Resolved! VTI problem

    Hello could anyone help me? I created VTI tunnels between HO and branches HO is 3925 and branches are 881 and 871, configuration is very basic and when traffic pass through tunnel ping rises very heavily from 200 to 1000 ms, CPU on 881 and 871 is...

baxta2712 by Level 1
  • 1041 Views
  • 2 replies
  • 0 Helpful votes

Hi, i have an ASA 8.2 and i set up a site to site vpn, the vpn is established correctly but only from the opposite side, i can not start it from my side. i m suppossed to NAT all traffic that goes to the tunnel from one host in the inside network usi...

Hi all I have a setup that gets to phase 2 and fails with the phone prompting to renter the username or password. Has any one got one of these to actually work?Sent from Cisco Technical Support iPad App

hi,Is it possible to setup a vpn connection between a vpn server and a remote access connection in network extension mode and initate the traffic flow from the server side?  I can bring the tunnel up by initiating the connection from the remote , but...

dhalevi by Level 1
  • 1147 Views
  • 4 replies
  • 0 Helpful votes

Please clarify this........Authentication (Identification of Peer):1. Using Symmetric Keys: Single key is used, the authentication of remote peer is not accurate when pre-shared key is stolen. So symmetric key alone is not efficient.2. Asymmetric Key...