VPN

PIX 501 running 6.3 on a 192.168.1.x LAN. Cisco VPN client (5.06) on an XP SP3 desktop running on a remote LAN set to 192.168.0.x. I need to be able to ping the desktop's NIC ip address of 192.168.0.11 I can ping the VPN group assigned IP address of ...

I have an ASA 5510 to control numerous SSL VPN connections, it is all up and running and working properly. however at the moment when a user logs in and use terminal services the system pre-populates the windows login screen with the username used du...

What version of the Cisco VPN client is supported on the MAC snow leopard? Thanks for any help.

I am doing a lab in dynamips trying to get an EasyVPN config working to a 3640. The lab requires me to use SDM to get everything setup. On my laptop I have Cisco VPN Client 5.0.05.0290 installed. I am able to connect to the EasyVPN server (HQ in the ...

Ip phone on remote site can not register on CUCS. VPN is up, pings are ok, I can ping from remote voice subnet to the local CUCS subnet. However, when IP phone tries to register with CUCS, I get the following:%ASA-6-302015: Built outbound UDP connect...

I have a Cisco 877W (IOS version 12.4(15)T9) setup at an office which is used primarily for Internet access for the users.  They have a requirement for remote workers to connect to resources sitting on the local LAN.  I have configured the router so ...

I'm troubleshooting some issues with a typical L2L VPN using IKE Main Mode w/pre-shared key auth.  I'm using an ASA 5550 w 7.2(3) code.I'm trying to find a way to disable the phase 2 security association lifetime kilobytes (traffic volume) rekey valu...

Custom with PIX515E, IOS 7.0.7I need to add a further site-to-site VPN.In this case, however, our partner asks not to present with the private IP of the inside net, but with a NATted one.From our part, it is all of our LAN that must participate in th...

I have a /29 public block on a PIX515A partner says I must proxy/NAT one of the public IPs in the tunnel instead of the internal private addressesDo I just need the additional global and a static NAT for the tunnel?

Hello,following situation:ASA 5520 running 8.0(4)28.Serving multiple VPN groups using either Anyconnect or VPN-Client.One of the Customers using group XXX does not want that his group is able to be etablished using anyconnect.User auth is done by an ...

Hi,There is a requirement to configure 2 gateway peers for a single tunnel. I dont see any command after "set peer" that would actually allow us to create a second peer for the tunnel. Is there a way to do this. Or if I give the command "crypto-map o...

Hi,I can make a remote access vpn with ASA using its outside IP, every thing goes well. As soon as I add static NAT on the router for ASA's outside IP & try vpn with the global IP following error comes on the ASA whereas I can see the translation on ...

Is it possible to create an IPSec tunnel between these two devices?