VPN

We have several Compaq 1700 laptops running Client 3.1 and Lotus Notes. After the client install everytime you hit send or forward in Notes, the screen goes blank and you have to reboot or you get a fatal exeception and you have to reboot. If you u...

I have 2 VPN routers setup for a site-to-site connection from site A to site B. Site A router A is also configured to allow client-to-site access using CISCOSecure VPN client 1.1 on remote machines. I need to know is it possible for a client on remot...

Is there a known issue with the above combination ?They seem to conflict. If installed VPN, I am unable to browse the internet. Without the Portal, it used to only affect during VPN dialed up. With it, I can not browse at all.Thanks.VP

I have setup the CSPM 2.3i to monitor and admin the Ciso IDS. Everything works great in the office. When I try to access the CSPM from a remote location via a connection with the CISCO VPN 3000 concentrator using the Cisco VPN client the CSPM runs ...

I have two sites with an ADSL internet Connection with Cisco 827, May I configure an IPSEC over GRE Tunnel? May I use this tunnel to transport voice traffic?Which is the HW requirements that must be satisfied?

I have 3 PIX 506 in a fully meshed network over IPSEC tunnel.I have on every PIX, fixup H323 1720 and an access-list IP permit LAN SOURCE LAN DESTINATION.Netmeeting doesn't work.Is any body have an explanation ?regardseric Pelletier

Good afternoon.We are trying to set up a 3DES tunnel via a Cisco 1750 with the 3DES feature set and a Windows 98 client with the Cisco Secure Client (not-unified). We were able to get the tunnel up and running, however we are unable to get any pings ...

If a have a 3000 series concentrator and an ACS server on the inside can I set authorizations to limit VPN clients access to specific resources?

Hi all,I have a rather simply question. I have recently purchased a Cisco Concentrator 3000 for my company and would like to deploy either on the DMZ or the external (outside the fw) using L2TP/IPSec. I want to know all of the pro and con regarding...

Hello! We're now using a PIX525, CiscoSecure ACS server for WinNT, VPN client 3.0.2 to build up a VPN enviroment for a large IDC. Since there are different groups of customer and should be permitted to access only their own group of servers, so the q...

I have the following setup :|Windows ME|----|adsl router|---internet ---->|cisco 1720 adsl| ---- |pix 506|--Enterprise networkSince I only have 1 public address on the Cisco 1720 adsl interface, how can I setup both the cisco 1720 adsl router and the...

Through dial up have no problem loggging on to my network with out using vpn client. When I use VPN through my ISP dialup account, recieve "no domain server was available to validate password. May not be able to gain access to some network resources....

I am having problems with my VPN clients using the VPN Client 3 software. In the version 1.1 software we could browse the web and see local network drives while connected using the VPN client. When we put version 6 software on our PIX 520 and started...

[Response] ddianisSep 25, 2001, 11:33am Pacific (15.)I have a VPN client that gets disconnected while using DSL with a message "IPSec terminated session". But the same laptop will stay connected for hours while using a dial connection. Where or how...

Dear all,Need your advise. I want to implement a VPN connection from client PC to PIX 515. My client PC is using PAT to access to the internet and I want my client PC to be able to access to internet and my VPN at the same time (split-tunnel??)Must...