04-10-2006 12:10 AM
2800 running with 12.4(4)T1 with HWIC-4ESW module. Can one define PPPoE
on a switchport interface? Ie:
interface FastEthernet0/1/0
pppoe enable
pppoe-client dial-pool-number 2
no routing dynamic
!
interface Dialer1
bandwidth 5000
ip address negotiated
ip mtu 1492
ip nat outside
ip virtual-reassembly
ip nat outside
ip virtual-reassembly
encapsulation ppp
dialer pool 2
dialer-group 2
no cdp enable
ppp authentication pap callin
ppp pap sent-username xxxx password 7 xxxxx
Thanks,
Hank
04-10-2006 01:01 AM
hi
the info available in CCO states that many of the features arent tested on this new module.
It goes on like this "Many features are not supported or tested on these interfaces, including Hot Standby Router Protocol (HSRP), Point-to-Point Protocol over Ethernet (PPPOE) termination, Layer 2 Tunneling Protocol Version 3 (L2TPv3) termination, MAC address assignment, Layer 3 QoS, and others. You should carefully test any desired feature and solution prior to deploying it"
http://www.cisco.com/en/US/products/ps5853/products_qanda_item0900aecd8016c026.shtml
regds
04-10-2006 04:13 AM
It works with Vlans:
interface FastEthernet0/1/0
switchport access vlan 10
no routing dynamic
!
interface Vlan10
ip address 10.10.0.1 255.255.255.0
ip nat outside
ip virtual-reassembly
pppoe enable
-Hank
04-14-2006 06:03 AM
Hi Hank,
Could you please elaborate on your working config as I am having trouble duplicating your results - would be hugely appreciated.
Thanks
Paul
03-31-2013 02:03 AM
Hi,
am trying this configuration on 1941 + HWIC-4ESW.
But it does not recognize the pppoe command !
router.xxxx.com(config)#int vlan 10
.........
router.xxxx.com(config-if)#pppoe enable
^
% Invalid input detected at '^' marker.
anyone was able to make it ?
am trying this on PT (before deploy)
regards,
Zied.
03-31-2013 03:03 AM
Cisco may now have coded to block that, as it was never stated supported.
Use a layer 3 interface, not VLAN interface.
03-31-2013 03:50 AM
Do you mean I'll have to use one of the Gpbs interfaces on the router ?
If yes that would be a big waste (Gbps on PPPoE ADSL)
I was wondering if I can, "any how" get PPPoE in one port from the HWIC-4ESW.
03-31-2013 04:29 AM
Can you tell me if this would work ?
Create a subinterface gigabitEthernet 0/0.1 and trunk it to one fastethernet from the HWIC-4ESW
after that configure a pppoe client on GE 0/0.1
I'll give it a try and come back to tell.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide