1- Problem in switching tcp / udp2- After locking the device (iphone & Ipad) the connection is lost and the reconnect enters the loop mode, especially in DTLS3- OnDemand mode exacerbates this issueThis has nothing to do with updated versions of the o...
Forum Posts
Hi,I have an FTD2140 running ASA and use management0/0 for SSH and HTTP management access to the firewall whether on-prem or remote. On the 9.12 train, we can manage the same firewall we are landing on with "management-access management". After upg...
Hello, A customer have more then 80 L2L VPN tunnels from their HQ to smaller remote offices. Primary the connections to those remote offices are via MPLS and the VPN tunnels are for backup purposes. When looking in FMC, I can see that most of the tun...
Resolved! Cisco Firepower FDM
NAT Exempt configuration for Sit to Site VPN traffic on our Cisco Firepower device managed via FDM. Currently, FDM does not allow ASA-style NAT commands (such as nat (...)) in the CLI or through FlexConfig. These commands are blocked because FDM uses...
Hello, A customer have some asymetric routing issues after a power outage on their local site. They are using MPLS as primary connection to their DC and a static L2L VPN connection as backup. There is a /18 network beeing anounced over MPLS from the ...
Need help updating my expired Personal Certificate - it expired while I was away on VTO.
Hoping to get some help or guidance on next step. I have a C1111-4p configured as a spoke that is on a LAN (i.e. NAT). The router is configured with a static IP on it's "outside" interface. Beyond this I have no control or insight. What I do know is ...
I have a computer that will need to be connected to another device using an ethernet connection and my network (ethernet preferred but will be fine connecting with Wi-Fi. The computer will recognize all connections simultaneously within "Network Conn...
Resolved! FTD Dynamic L2L VPNs
Hello, We want to have a FTD (with static public IP) and several Cisco routers (with dynamic IP) connected with IPSEC IKEv2 L2L VPNs with different PSKs for each VPN. We dont find on the FTD how to check the receiving ID that the router would send t...
Hi,I have a VPN setup between two cisco IOS routers running IKEv2It works fine with no issuesI see the logs below and Im not sure I understand what they are.I see IKEV@-5-SA_DOWN every time the IKEv2 SA lifetime is up and renews. I also changed the l...
Hi Team! I have a question for you — is it possible to configure AnyConnect to work in the following way:First, it tries to establish a connection using IPSec, but if it cannot (for example, because the user is at an airport where UDP ports 500/4500 ...
Hello,I have been receiving continual pop ups for several weeks from Cisco Secure Client on my corporate Macbook saying "The VPN client agent was unable to create the interprocess communication depot." This pop up interrupts whatever I will be workin...
Hello, we're running Cisco Anyconnect 4.2 NAC to connect to our VPN. I'm running into an issue where it's telling me that there are no network adapters. I've tried uninstalling/re-installing the network adapter drivers, Cisco NAC and I just can't get...
Hope this helps someone. I went through a newly developed issue regarding Site to site tunnels. I had to make a new site to site tunnel between two sites. I routed all DNS through the tunnel to a DNS server on the other side until I could create a DN...
Hello,I am experiencing a problem when using Cisco AnyConnect VPN to connect to my university network. When the VPN is active:WinSCP freezes or disconnects immediately when trying to access my HPC cluster (Stromboli).University websites such as Moodl...
