cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
424
Views
10
Helpful
1
Replies

Webex edge for devices - SW version of DX80

osmannayeem
Beginner
Beginner

After connecting all our video devices with control hub, we noticed room devices or webex whiteboard upgraded to Room OS. However, DX80 and other old devices are still in CE15.6. Is this an expected behavior or all should be upgraded to Room OS?

1 Accepted Solution

chthorpe
Cisco Employee
Cisco Employee

Hi, Webex Room Series, Board Series, Kit Series and Desk Pro will show RoomOS 10.x.x.x (current stable version is 10.6.1.1)

Older generation devices such as SX Series, MX 200G2, MX300G2, MX700/800 and DX70/DX80 will show CE 9.15.x.x (current stable version is CE 9.15.6.17).

If the DX80 was fully cloud registered, then it would show a RoomOS9.15.6.17.

 

Your build on your DX80 is running RoomOS9, it is just that as it is Edge for Devices registered, it reports it as CE9.15.x.x

 

SX Series, MX Series (mentioned above) and DX 70/80 do not support RoomOS 10

 

Hope that helps

View solution in original post

1 Reply 1

chthorpe
Cisco Employee
Cisco Employee

Hi, Webex Room Series, Board Series, Kit Series and Desk Pro will show RoomOS 10.x.x.x (current stable version is 10.6.1.1)

Older generation devices such as SX Series, MX 200G2, MX300G2, MX700/800 and DX70/DX80 will show CE 9.15.x.x (current stable version is CE 9.15.6.17).

If the DX80 was fully cloud registered, then it would show a RoomOS9.15.6.17.

 

Your build on your DX80 is running RoomOS9, it is just that as it is Edge for Devices registered, it reports it as CE9.15.x.x

 

SX Series, MX Series (mentioned above) and DX 70/80 do not support RoomOS 10

 

Hope that helps

Getting Started

Welcome to the Webex Community. This is your home to ask questions, share knowledge, and attend live webinars.

Recognize Your Peers