% Invalid input detected at '^' marker.

[F5MZE]

Hi there,

Trying to access to the config terminal, I get error 

% Invalid input detected at '^' marker.

Here is my process :

Login to my access point via ssh

login as :admin

Using keyboard-interactive authentication.

Password:xxxxxxxxxxx

AP>enable

Password:xxxxxxxxxx

AP#configure terminal

        ^

% Invalid input detected at '^' marker.

AP#

Any idea ? Thanks for helping

[Jagermaister]

You can also try use conf t to go into configuration part

[F5MZE]

Thnks but doesn't work either

[balaji.bandi]

try config t  (same as you tried - but short cut see if that works?)

What is the model of the AP / IOS Code running  - is this registered with WLC ? or standalone mode ?

[F5MZE]

Hi BB,

This is the Cisco Aironet 2700 Series (IEEE 802.11n) Access Point running Cisco IOS Software, C2700 Software (AP3G2-K9W8-M), Version 15.3(3)JA10, RELEASE SOFTWARE

Registered with WLC

[balaji.bandi]

If that is registered with WLC, you cam manage using WLC only you have less capability to change anything.

what is the reason you looking to use config t ?

[F5MZE]

I want to define snmp community. 

I can't define thru WLC

[balaji.bandi]

As i mentioned i dont believe you can do while WLC  based setup the APs do not support SNMP,

you need poll   WLC IP for SNMP.

[F5MZE]

Have 19 AP WLC based with the same WLC and was able to do it on all of them except this one.

My real problem is I can't go to the 'Configure Terminal' environment on this one AP

[balaji.bandi]

Have 19 AP WLC based with the same WLC and was able to do it on all of them except this one.

My real problem is I can't go to the 'Configure Terminal' environment on this one AP

Oh, you mean 18 AP device you able to config t and make config changes ? and 19th one you not able to change the config ?

what WLC ? Model and Code running ?

[F5MZE]

Oh, you mean 18 AP device you able to config t and make config changes ? and 19th one you not able to change the config ?

Yes

WLC is Model 2504 running 8.0.140.0 version

[balaji.bandi]

Thank you for the input, i never had chance to access AP cli  while manging with WCL and Prime (i may be wrong, this may be be  possible)

Look at the config more :- compare with working with not working ? ( access point section)

https://www.cisco.com/c/en/us/td/docs/wireless/controller/8-0/configuration-guide/b_cg80/b_cg80_chapter_011111.html

[F5MZE]

thanks for your link. Unfortunately, access is forbidden

[F5MZE]

Hi BB, this moning, the link rocks

[balaji.bandi]

Nice to know the Links works, Hope that help you.