[RTMT-ALERT-StandAloneCluster] DBReplicationFailure

[virendra pathak]

Dear All,

I am getting frequently error from RTMT tool as error is mentined below. I need explanation on this and solution also.

It is highly appreciated.

 n Thu Aug 20 11:47:27 IST 2015, alert DBReplicationFailure has occured. Counter Replicate_State of Number of Replicates Created and State of Replication(ReplicateCount) on node ( IP ADD HERE) state value of 3. ReasonCode: Replication data transfer is bad in the cluster.

Regards

Shirin

[eric.ahernandez]

Hi Shirin,

Is this a Cluster-over-the-WAN scenario? If so it could be a delay problem, you make sure you're not exceeding 80ms round-trip time.

[virendra pathak]

Hello All,

This alerts is generating due to expiry of CA Certificate. Is it possible?

Thanks to all.

Regads

Shirin

[avinsrid89]

Replication does not break due to certificates. Please provide the outputs as asked for.

[moyo oyegunle]

Did you recently add another node or similar changes.

Kindly confirm the runtimestate of the cluster?

[avinsrid89]

Please give following output from publisher:

utils dbreplication runtimestate

utils dbreplication status --> pull the logs from the location given

utils service list --> from all servers in cluster

run select * from processnode --> from all servers in cluster

Also get the data base report from Cisco Unified Reporting --> CM Database Status

Execute utils network ping from publisher to all servers in cluster. Similarly for each of the subscriber also. See what results you get?

~Avinash