12-21-2012 10:33 AM
WAP121 We have configure couple of WAP 121 device with configuration and there was a power glitch , it got reset by itself, pls
Solved! Go to Solution.
12-21-2012 10:40 AM
Hi Dheeraj, the device has a running config. When you make a change to the unit, it will not save until you save the running config to the start up config. It sounds like the unit was configured but never saved.
-Tom
Please mark answered for helpful posts
12-21-2012 10:40 AM
Hi Dheeraj, the device has a running config. When you make a change to the unit, it will not save until you save the running config to the start up config. It sounds like the unit was configured but never saved.
-Tom
Please mark answered for helpful posts
12-21-2012 10:58 AM
thanks for the reply Tom, we did save the configuration and the device was off for a day , then we put it on a network the configuration was there , it worked for more than two weeks, but is it possible that it both devices got reset due to power glitch?
12-21-2012 11:36 AM
is somebody can help me to resolve this issue, will appreciate for reply, thanks
12-21-2012 12:20 PM
Dheer, on older firmwares, there were bugs when using things like UK time zone, when rebooting the unit, it would factory default. Last I knew, those bugs had been resolved on the latest firmware. If I'm not mistaken, that bug included places like United Emirates so I do not know what extent it could affect other time zones.
This is the only reason I could figure you'd randomly drop config if you saved the configs correctly.
So the tl;dr (too long didn't read) answer would be to make sure you're on the latest firmware and test your time zone by adjusting it, save the config, reboot the unit or try to emulate a power outage to see what happens.
-Tom
Please mark answered for helpful posts
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide