3650 WLC, switch3560, TWO AP -problem is joind secend

[tomasznowak2]

Good Moring,

i have a problem with wlc 3650

My problem is AP2(second) is not Join to :

WLC *Mar 2 15:16:49.180: *%CAPWAP-3-PHY_PORT_ERR2:Switch 1 R0/0: wcm: Cannot process capwap packet from AP e00e.dabc.16f0, since there is another AP (e00e.dac1.ff20) already join with same physical port.

but AP1(first) is connect and ok..

SW1<->SW2

switch access vlan 100

switch mode access

SW2 to AP 1 & AP2

switch access vlan 100

switch mode access

where is problem?

[Sandeep Choudhary · Accepted solution]

As far as i know, you must connect both AP in 3650 switch diretly else it will not work.

Regards

Dont forget to rate helpful posts

[tomasznowak2]

---

@Sandeep Choudhary wrote:

As far as i know, you must connect both AP in 3650 switch diretly else it will not work.

Regards

Dont forget to rate helpful posts

---

Why ? soft limit?

[Sandeep Choudhary]

its a requirement from cisco side:

chekc point 1 on this post:

https://mrncciew.com/2013/09/29/getting-started-with-3850/

Regards

Dont forgte to rate helpful posts