03-02-2020 06:00 AM - edited 07-05-2021 11:47 AM
Good Moring,
i have a problem with wlc 3650
My problem is AP2(second) is not Join to :
WLC *Mar 2 15:16:49.180: *%CAPWAP-3-PHY_PORT_ERR2:Switch 1 R0/0: wcm: Cannot process capwap packet from AP e00e.dabc.16f0, since there is another AP (e00e.dac1.ff20) already join with same physical port.
but AP1(first) is connect and ok..
SW1<->SW2
switch access vlan 100
switch mode access
SW2 to AP 1 & AP2
switch access vlan 100
switch mode access
where is problem?
Solved! Go to Solution.
03-02-2020 06:09 AM
As far as i know, you must connect both AP in 3650 switch diretly else it will not work.
Regards
Dont forget to rate helpful posts
03-02-2020 06:09 AM
As far as i know, you must connect both AP in 3650 switch diretly else it will not work.
Regards
Dont forget to rate helpful posts
03-02-2020 06:20 AM
@Sandeep Choudhary wrote:As far as i know, you must connect both AP in 3650 switch diretly else it will not work.
Regards
Dont forget to rate helpful posts
Why ? soft limit?
03-02-2020 06:31 AM
its a requirement from cisco side:
chekc point 1 on this post:
https://mrncciew.com/2013/09/29/getting-started-with-3850/
Regards
Dont forgte to rate helpful posts
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide