11-16-2016 12:30 PM - edited 07-05-2021 06:07 AM
Upgraded the lab controller to 8.2.130 to test some 3802i's we got. Access points come up fine, but WLANs don't broadcast (or even show up). Put a 2602 on there and it works fine, test WLANs broadcast and we are able to connect. For some reason the 3802s just aren't working. Any ideas?
Solved! Go to Solution.
11-17-2016 12:34 AM
HI,
Is the SSID/WLAN configured to use TKIP?
Please note that TKIP is not supported yet with the 3802 AP's. If this is configured, the SSID will not show up. Check this link for more info:
http://www.cisco.com/c/en/us/td/docs/wireless/controller/technotes/8-3/b_cisco_aironet_series_2800_3800_access_point_deployment_guide/b_cisco_aironet_series_2800_3800_access_point_deployment_guide_chapter_01100.html
Regards
Dont forget to rate helpful posts
11-17-2016 12:34 AM
HI,
Is the SSID/WLAN configured to use TKIP?
Please note that TKIP is not supported yet with the 3802 AP's. If this is configured, the SSID will not show up. Check this link for more info:
http://www.cisco.com/c/en/us/td/docs/wireless/controller/technotes/8-3/b_cisco_aironet_series_2800_3800_access_point_deployment_guide/b_cisco_aironet_series_2800_3800_access_point_deployment_guide_chapter_01100.html
Regards
Dont forget to rate helpful posts
11-17-2016 07:11 AM
wow, that did it! we had wpa/tkip and wpa2/aes on the wlan, i never thought to disable tkip (knowing that it wasn't supported). Thanks!
11-17-2016 11:09 PM
Great. Thanks for rating.
Regards
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide