4.2.207.0 to 4.2.176.51M

[mimidi209]

We have WLC 4402 software version 4.2.207.0 and LWAP 1510

Our wireless network is mesh but i don't know why this release support mesh access point because i found below text in Cisco help center:

"Do not upgrade to controller software release 4.2.207.0 if you have mesh access points in your network. If your network uses mesh access points, use only mesh-specific releases."

now we want to migrate our controller to release 4.2.176.51M-MESH.aes, I want to know after that is there any problem such as reset factory, AP not join to the controller, etc...

Thanks

[Surendra BG]

GO for 4.2.207.54 M code this supports 1505 and 1510

(Release 4.2.207.54M supports Cisco 1500 (1505 and  1510) Series Outdoor Mesh Access Point.This release is the only 4.2  mainstream controller release that supports the 1505 and 1510. )

Here is the reelase notes for the same

http://www.cisco.com/en/US/docs/wireless/controller/release/notes/crn4220754M.html#wp1097065

Here is the link to download the image as well!

Please dont forget to rate the usefull posts and Mark it as answered if it answered ur question!!

Regards

Surendra

[mimidi209]

Thanks for your quick reply, we haven't service contract to download software image 4.2.207.54M

Now we have only release 4.2.176.51M

Surendra, are you sure that after upgrade 4.2.207.0 to 4.2.176.51M the controller and AP's work properly?

[Surendra BG · Accepted solution]

Its the same Train and it will work properly!! the release notes will be urt best frnd as well!!

Regards

Surendra