02-06-2012 05:04 PM - edited 07-03-2021 09:31 PM
Hi All,
We have a 4402 Wireless Controller. However, our AP's are from another manufacturer (Meraki MP12). Is it possible that the 4402 can "control" the Meraki MP12?
Thanks - Joe
Solved! Go to Solution.
02-06-2012 05:20 PM
Is it fair to say that the Cisco 4402 controller will only support Cisco AP's?
This is correct.
The Cisco WLC will NOT support the AP540 nor the Linksys-branded WAP.
The Release Notes will tell you which firmware will support which WAP models.
02-06-2012 05:09 PM
If you take a look at the release note, depending on what code versions, it will the supported equipment... Of course it is all Cisco gear.
Sent from Cisco Technical Support iPhone App
02-06-2012 05:10 PM
I would have to say no.
Thanks,
Scott Fella
Sent from my iPhone
02-06-2012 05:12 PM
Is it possible that the 4402 can "control" the Meraki MP12?
No.
02-06-2012 05:16 PM
Leo,
Can I take it a step further? Is it fair to say that the Cisco 4402 controller will only support Cisco AP's?
Thanks again.
02-06-2012 05:20 PM
Is it fair to say that the Cisco 4402 controller will only support Cisco AP's?
This is correct.
The Cisco WLC will NOT support the AP540 nor the Linksys-branded WAP.
The Release Notes will tell you which firmware will support which WAP models.
02-06-2012 05:21 PM
Good. That's what I wanted to hear. Thank You !!
02-06-2012 05:22 PM
Sorry, you were too fast. I edited my last post to provide further information.
Thanks for the ratings.
02-06-2012 05:23 PM
Yes... It will list the supported devices in the release notes.
Thanks,
Scott Fella
Sent from my iPhone
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide