702w - Information on LAN ports

[Colleen Morrissey]

I am using the 702w AP on a controller running 8.0.133.0 code and using the 4 LAN ports on the AP.

For the LAN ports - I want to be able to see a port and see what MAC address is learned on that port.

Would also like to see basic stats to look for errors/duplex mismatches.

I can't seem to get this info from the controller (via GUI or CLI).

Enabled telnet to 702w and can't even find a local mac address table or otherwise there.

Is this possible?

[raymond.doherty]

I was not able to find mac address information off the ports and the only place I was able to find any information on the lan port was by accessing the AP using SSH and using "show tech".  I output it to a text file and  searched for "lan4 status" in the output.

LAN4 Port status : Link Down    Admin state: ENABLED
Status register : (84) 0
 Switch Port 4 statistics Base 1200

A port with a cable plugged in looks like this:

LAN1 Port status : Link UP    Admin state: ENABLED
Status register : (90) 0
 Switch Port 1 statistics Base 1500

I suspect there is an easier way to query this but I can't find the command.

[Robin Burns]

I don't see it anywhere else either.  It's crazy that they don't appear on the interfaces list under

     show interfaces summary

The replacement 1815W will show you traffic stats on those ports from the controller GUI.  But implementing VLAN's different from the AP's uplink VLAN is much more complicated.