Ask Me Anything Event Welcome to the Cisco Community Ask Me Anything conversation. Submit your questions from Monday, August 4, 2025 through Friday, August 15, 2025. Our colleagues Saikat Nandy and Parithosh Vema will be waiting to assist you ...
Forum Posts
Sorry for the newbie question.Can someone give me a line by line instructions to change the txPower level of the 5Ghz radio? Or is there an easy GUI that I can use? I have tried to follow the Cisco wireless access point configuration guide, but none ...
Hi, I will be migrating some wireless traffic that passes via our WLC from one ISP to another. The new ISP is using their gateway as a DHCP relay (as server sits in the WAN), and The wireless clients are proxying their DHCP requests via the wireless ...
Hi,I am trying to set up my (just opened) WAP 121. I bought it three years ago, and now have use for it.The manual advises to use the 'FindIT Network Discovery Utility', which will allow me to log into the WAP 121, and start the 'Wizard' to turn on t...
Hi Team , We are working with Monitoring_tool vendor for setting up a URL monitoring for WLC GUI url based on the sessionID cookie . We would like to know if the WLC device reboots will the session ID on WLC gets deleted or removed ?
My office existing four Aironet 1815 (Use Mobility Express for Controller), Now I would like to add new two AP to my office and I plan to use Catalyst AP for new two AP.I Would like to know can I use Catalyst 9K series AP for control my existing Airo...
Hello I have a doubt about access point data sheets, more specifically about rx sensitivity. Using as example AP 1540 Series data sheet: for 802.11g and data rate 54 Mbps, the informed rx sensitivity is -79 dBm. Does that mean that, at the floor lev...
We are currently replacing all our AP's with Meraki MR56, therefore I want to use the 2702I at home They are currently setup in lightweight mode and connect to a WLC - I have read many articles on setting them up as autonomous mode but get different ...
Resolved! Questions regarding WLC 2504 and HA
Dear All,We have got two 2504 WLCs. And we plan to have HA for those WLCs.As we are not quite familiar with Cisco WLC, please allow us to ask questions here. For those WLCs, one is with AP licensed while the other just comes with a base license.Obvio...
Resolved! Cisco 1832 solid amber
Hello. I've got Cisco AP model AIR-AP1832I-R-K9, It has solid amber light when power on. Ethernet port is not activated, and factory reset does not have any affects. I got nothing on console port when power on.Is this recoverable or it is dead?
Hello, we have wlc 3504 whose ios needs to be upgraded. Do we need to check flash space size to make sure there is enough space before upgrading ios? If new ios can replace old ios so that old one will be deleted automatically, we do not need to care...
We have WiFi 6 enabled in our infra. Is there any possibility to get evidence /Reports from WLC to see Wifi6 is working fine on the WLC.
Good day, I would like to find out if it's possible and perhaps advisable to use a DNA center appliance to control access points with No WLC?
Hi When AP is at global mode under Tx Power Level Assignment, its power level can change automatically. Anyone can explain based on what the power level of AP change? In other words, what can cause the power level change? Thanks
Hello, We have Cisco Aironet 1800s sensors deployed in our SDA network. Following is what I would like to get more understanding on.1. For the RADIUS test that the sensors can perform, I was reading somewhere that it’s tricky as the sensor do not hol...
