cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
526
Views
10
Helpful
5
Replies
_Chris_
Beginner

8500 WLC Static IP Issue

Hello,

 

I had a few printers yesterday that were showing up in the WLC without an IP address (0.0.0.0). These printers are being configured with static IP's. I looked up my "symptom" and read about unchecking the DHCP Addr. Assignment in the advanced tab of a WLAN. So I went and did that. After this some printers were able to print but now I have about 4 printers that still show 0.0.0.0. Not sure what else to do since unchecking that box seemed to fix the problem for the majority of the people that have already posted about it.

 

 

1 ACCEPTED SOLUTION

Accepted Solutions
Rasika Nayanajith
VIP Mentor

Did you try to disconnect & reconnect those clients ?

You can use "config client deauthenticate <mac_addr>" or GUI (Monitor -> Client -> select client & remove)

 

HTH

Rasika

*** Pls rate all useful responses ***

View solution in original post

5 REPLIES 5
Rasika Nayanajith
VIP Mentor

Did you try to disconnect & reconnect those clients ?

You can use "config client deauthenticate <mac_addr>" or GUI (Monitor -> Client -> select client & remove)

 

HTH

Rasika

*** Pls rate all useful responses ***

View solution in original post

I appreciate the response Rasika.

 

After I remove the client (through GUI) will I need manually re-enter the static IP address on the printer? The printer is in another building... Just want to make sure if I need to plan to make a trip to this device.

Hi Chris,

No, you do not want to manually add client. It should connect to wireless using static IP.

 

HTH

Rasika

Thank you, your suggestion resolved my issue.

Good to hear that Chris.

 

Thanks for rating as well.

 

Rasika

 

 

Content for Community-Ad