cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
5647
Views
4
Helpful
3
Replies

Access point location command invoked

Hi,

 

We have a couple of 2602e access points on which the led status is cycling through blue, green, red and off. In the data sheet it states that this message mean: Access point location command invoked. But i am not really sure what is means exactly and how to fix this issue.

 

Does anyone has an idea about this? 

3 Replies 3

Hi,

Is this a Lightweight or stand alone  AP, the location command invoked so that the physical location of the AP can be identified. 

Hi,

 

These are lightweight access point connected to a cisco 3650 switch/controller. What can i do to fix this and get the AP's back online?

mohanak
Cisco Employee
Cisco Employee

Access point location command invoked : That text in the guide means that you went into the command line of the AP and issued the command to cycle the LEDs as a method to find the AP if your were walking around head to the top to find a particular AP.

To make a specific access point to flash its LEDs for a specified number of seconds, enter this command:

debug ap command "led flash seconds" your_access_point_name

You can enter a value between 1 and 3600 seconds for the seconds parameter.

To disable LED flashing for a specific access point, enter this command:

debug ap command "led flash disable" your_access_point_name

You can disable debug mode once you’ve located you AP by using this command or simply close your ssh session

debug ap disable your_access_point_name

 

http://www.cisco.com/c/en/us/td/docs/wireless/controller/7-5/configuration-guide/b_cg75/b_cg75_chapter_01111011.pdf

Review Cisco Networking for a $25 gift card