cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
3945
Views
5
Helpful
3
Replies

Adding an Access Point to Mobility Express Network

Ravan Nagalingam
Beginner
Beginner

HI,

Can a new 1850 AP join and existing Mobility Express Network, if there aren't any dhcp server in my enviroment to lease out ip for the new ap.

The new AP details as below :-

AP Running Image     : 8.3.102.0
Primary Boot Image   : 8.3.102.0
Backup Boot Image    : 0.0.0.0
AP Image type    : MOBILITY EXPRESS IMAGE
AP Configuration : MOBILITY EXPRESS CAPABLE

3 Replies 3

Yashas Bhadoria
Cisco Employee
Cisco Employee

If you have an existing WLC you can configure it on WLC.

For other config options please refer the following Guide:

http://www.cisco.com/c/en/us/td/docs/wireless/access_point/1850/hardware/guide/ap1850hwguide.html

Hi Yashas,

You mean that i will be able to detect the new AP i plug in to the network on the Mobility Express Controller page even though the new AP does not have any IP address since there is no dhcp server leasing out ip for the new AP.

Both the Controller AP & the new AP are running the same image code (8.3.102.0).

1. set a static IP on AP, mask, gw.   Broadcast should then find controller.

2. Or else, set your Controller IP in your new AP.

 

1#lwapp ap ip address <IP address> <subnet mask>
1P#lwapp ap ip default-gateway <IP-address>
2P#lwapp ap controller ip address <IP-address>

 

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: