08-18-2015 12:26 PM - edited 07-05-2021 03:47 AM
HI,
I need to add 2 new vlans to the trunk between the WiSM2 and the 6513 chassis. The WiSM is in slot 13 of the chassis and I want to ensure that adding the new Vlans won't disrupt the current connections.
Thanks,
Waqas
Solved! Go to Solution.
08-18-2015 01:14 PM
Just 1 thing to note, adding a vlan to a trunk is a non service effecting change and should not cause issues but you have to remember your stp and if by set by default will be using pvst on the 6513 so there will be a layer 2 calculation for that vlan,if just 1 trunk it should go straight to fwd but if multiple there may be a slight calculation to prevent any loop but this should not be noticed by end users, always good to have a small maintenance window in case something goes array anyway but in general nothing wrong should happen just make sure the add part is in the command or you will over write the current trunk config
08-18-2015 01:14 PM
Just 1 thing to note, adding a vlan to a trunk is a non service effecting change and should not cause issues but you have to remember your stp and if by set by default will be using pvst on the 6513 so there will be a layer 2 calculation for that vlan,if just 1 trunk it should go straight to fwd but if multiple there may be a slight calculation to prevent any loop but this should not be noticed by end users, always good to have a small maintenance window in case something goes array anyway but in general nothing wrong should happen just make sure the add part is in the command or you will over write the current trunk config
08-18-2015 01:31 PM
Thanks Mark
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: