08-31-2023 10:02 PM - last edited on 08-31-2023 10:48 PM by rupeshah
Hi,
Suddenly one of our 1832 stops working. In serial console I get repeatetly output like this
GPVTG,,T,,M,,N,,K,N*2C
$GPGSA,A,1,,,,,,,,,,,,,,,*1E
$GPGGA,,,,,,0,,,,,,,,*66
$GPRMC,,V,,,,,,,,,,N*53
$GPGSV,3,1,12,01,08,240,,03,45,135,,04,62,240,,06,26,239,*7E
$GPGSV,3,2,12,07,05,340,,08,46,102,,09,,,,11,66,262,*48
$GPGSV,3,3,12,13,02,060,,15,,,,16,46,175,,17,20,284,*44
$GPVTG,,T,,M,,N,,K,N*2C
$GPGSA,A,1,,,,,,,,,,,,,,,*1E
$GPGGA,,,,,,0,,,,,,,,*66
$GPRMC,,V,,,,,,,,,,N*53
poe status on switch remains on 1%, link goes to off
led is fast flashing between amber, red and green (end state after approx. 5 minutes)
Is there any chance to get a normal prompt on console?
Thx in advance
Go
08-31-2023 10:06 PM
@gotthardanger normally, when AP flashing all colours that means its trying to find a controller. is this controller based? try changing your baud rate to 9600 in console settings.
08-31-2023 10:12 PM
yes, it´s controller based. I´m wondering because the ap disconnects from switch (ap doesn´t show up in mac address table of the switch)
changing serial connection to 9600 has no effects
08-31-2023 10:30 PM
additional information: I tried some factory rest procedures (mode button - wait until led shows red or amber - release)
the console output doesn´t change. I have to assume the boot code is damaged
08-31-2023 10:44 PM
@gotthardanger in that situation, its better to contact TAC and try to resolve issue.,
09-01-2023 12:08 AM
RMA the AP.
1800 are well known to have (high) failure rates.
09-01-2023 03:04 AM
Support case is opened
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide